Show Segment - Compaq AA-Q88CE-TE System Manager's Manual

SHOW SEGMENT

Display the type and size of routing key segments.
Format
SHOW SEGMENT
Command Qualifiers
/CLUSTER
/FACILITY
/FULL
/NODE[=node-list]
/OUTPUT[=file-spec]
Description
The
SHOW SEGMENT
The routing key
The routing key specifies the data within a message sent from clients used to
route the message to a particular key range server.
The position, length and data type of each key segment is displayed.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FACILITY
/FACILITY="*" (D)
Specifies the facility name for which information should be displayed.
By default, information is displayed for all Facilities.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
/OUTPUT
command displays the routing key segment definitions.
is common to all servers in a facility.
definition
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
is omitted then the command is executed only on the node where the
or is omitted then the standard or default output is used.
file-spec
Defaults
/NOCLUSTER
/FACILITY="*"
/NOFULL
/NODE=default-node-list
/OUTPUT=stdout
command. If no
RTR Command Line Interface 6–163
SHOW SEGMENT
SET ENVIRONMENT
. If
node-list
file-spec . If