Log - Compaq AA-Q88CE-TE System Manager's Manual

LOG

LOG
Specify RTR to write a log message to a log file.
Format
LOG
Command Qualifiers
/CLUSTER
/NODE=node-list
/OUTPUT[=file-spec]
Description
The LOG
You can write log messages to the operator console and to a maximum of four log
files. Log files must be periodically purged to avoid difficulties with full disks. Do
this by using
If neither the
suppressed.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
/OUTPUT
Related Commands
•
SHOW LOG
6–96 RTR Command Line Interface
command specifies a defined log entry to be written to its log messages.
to specify a new file and deleting the old one.
SET LOG
nor the
/OPERATOR
/NODE nor /CLUSTER is specified then the command is executed on the
SET ENVIRONMENT
is omitted then the command is executed only on the node where the
or is omitted then the standard or default output is used.
file-spec
Defaults
/NOCLUSTER
/NODE=default-node-list
/OUTPUT=stdout
qualifier is specified then logging is
/FILE
command. If no
SET ENVIRONMENT
. If
node-list
. If
file-spec