Show Link - Compaq AA-Q88CE-TE System Manager's Manual

SHOW LINK

SHOW LINK
Display the configuration and status of the links to other nodes.
Format
SHOW LINK [node-name]
Command Qualifiers
/CLUSTER
/COUNTER[=counter-name]
/FACILITY
/FULL
/NODE[=node-list]
/OUTPUT[=file-spec]
/STATE
Description
The
SHOW LINK
nodes. If no qualifiers are given, a brief display of the links is shown.
Parameters
node-name
Specifies the name of a node; the parameters for the link to this node are
displayed.
matching links will be displayed. If
displayed.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNTER[=counter-name]
/NOCOUNTER (D)
Specifies that the link counters are also to be displayed.
name of the counter to be displayed. If
will be displayed.
/FACILITY
/NOFACILITY (D)
Specifies that the names of facilities using the link are also displayed.
6–144 RTR Command Line Interface
Defaults
/NOCLUSTER
/NOCOUNTER
/NOFACILITY
/NOFULL
/NODE=default-node-list
/OUTPUT=stdout
/NOSTATE
command shows the configuration and status of the links to RTR
Node-name may contain wild cards ("*" and "%"), in which case all
/NODE nor /CLUSTER is specified then the command is executed on the
SET ENVIRONMENT
may contain wild card characters.
Counter-name
is omitted all known links are
node-name
command. If no
Counter-name
counter-name is omitted then all counters
SET ENVIRONMENT
is the