Parameters For Rtr_Reply_To_Client - Compaq AA-Q88CE-TE System Manager's Manual

CALL RTR_REPLY_TO_CLIENT
Table 6–11 Parameters for rtr_reply_to_client
C Parameter Name C Parameter Value
channel
flags RTR_NO_FLAGS
RTR_F_REP_ACCEPT
pmsg, msglen,
1
msgfmt
1
The actual values used for
command line parameter.
The command server uses message data specified as command line parameter
values to generate a record containing the message data (for the
the message length (for the
the msgfmt
Qualifiers
/ACCEPT
/NOACCEPT
The /ACCEPT qualifier sets the flag RTR_F_REP_ACCEPT in the call to
reply_to_client( )
/CHANNEL_NAME=channel_name
/CHANNEL_NAME=RTR$DEFAULT_CHANNEL
Specifies the channel for which the operation is to be performed.
The command server uses a combination of the channel_name and the window
from which the call was issued to uniquely identify which channel to use.
channel_name
The default channel name is RTR$DEFAULT_CHANNEL.
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FORMAT[=fmt-string]
/NOFORMAT (D)
Specifies that a format string should be sent with this message.
If /FORMAT is specified without
format string. The format string is generated using the parameters given for
the qualifiers /SIGNED, /UNSIGNED, /STRING and /LENGTH. The following
table shows permitted values for these qualifiers when using /FORMAT without
fmt-string
6–32 RTR Command Line Interface
pmsg msglen msgfmt
, and
msglen
parameter).
. It means the transaction is accepted by this server.
is not case sensitive.
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
.
Command Line Specification
/CHANNEL_NAME=name
none [D]
/ACCEPT
[message definition parameter list with positional
qualifiers.]
are based upon the message definition you specify as a
parameter), and a record type description (for
command. If no
fmt-string , RTR automatically generates a
parameter),
pmsg
SET ENVIRONMENT