Valid Transaction State Changes - Compaq AA-Q88CE-TE System Manager's Manual

/NEW_STATE
Specifies the new transaction state that selected transactions will be changed to.
This qualifier is required and new state value must be specified.
Value of
ABORT
COMMIT
DONE
EXCEPTION
Note that one cannot always change a transaction's state from one legitimate
transaction state to another. Some state changes are not valid. The following
table shows state changes that are valid.
Table 6–19 Valid Transaction State Changes
Current State
SENDING
VOTED
COMMIT
EXCEPTION
PRI_DONE
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
/OUTPUT
/PARTITION
/PARTITION=partition_name
Specifies the name of a partition from which all transactions are running within.
A partition name must be supplied.
Use SHOW PARTITION to view the names of the currently active partitions.
/SINCE[=date]
Selects only those transactions whose timestamp is after the specified date.
Default is the current date.
Related Commands
• SHOW TRANSACTION
•
DUMP JOURNAL
may be one of the following:
new_state
COMMIT ABORT
YES
YES YES
YES
is omitted then the command is executed only on the node where the
or file-spec is omitted then the standard or default output is used.
SET TRANSACTION
NEW STATE
EXCEPTION DONE
YES YES
YES
YES
node-list
file-spec
RTR Command Line Interface 6–127
. If
. If