SET ENVIRONMENT
SET ENVIRONMENT
Specify the node(s) where subsequent RTR commands are executed.
Format
SET ENVIRONMENT
Command Qualifiers
/CLUSTER
/NODE=node-list
Description
The
SET ENVIRONMENT
on the specified nodes. Entering
subsequent RTR commands to be executed on the local node only.
Qualifiers
/CLUSTER
Currently only fully supported in an OpenVMS environment, in which case
it specifies that subsequent RTR commands are executed on all nodes in the
VMScluster.
For other implementations, using /CLUSTER is interpreted as /NODE=this_node
/NODE[=node-list]
Specifies that subsequent RTR commands are executed on all nodes specified in
node-list
omitted then subsequent commands are executed on only the local node.
Related Commands
•
SHOW ENVIRONMENT
Examples
See Section 1.5, Remote Commands, for examples of how to use the
ENVIRONMENT
6–108 RTR Command Line Interface
Defaults
/NOCLUSTER
/NODE=this_node
command causes subsequent RTR commands to be executed
SET ENVIRONMENT
. If
is omitted or both the
node-list
command.
without any qualifiers causes
and
qualifiers are
/NODE
/CLUSTER
SET