Router Partition States - Compaq AA-Q88CE-TE System Manager's Manual

Table 6–21 Router Partition States
State
BLOCKED
ACTIVE
CATCHUP
TAKEOVR
LAGGING
Qualifiers
/BACKEND
/NOBACKEND (D)
Displays information about backend partitions; it shows the partition state and
low and high bounds. /BACKEND with /FULL provides more detailed information
for a partition, giving the current queue depth (transactions active) on a partition.
This is useful for determining whether a server is processing transactions
correctly.
fetched;
The default is to output brief router and backend information.
/BRIEF
/NOBRIEF (D)
Brief output gives a one line listing of each partition in the system, showing the
partition name, the facility in which it resides, and the partition state. Since
space on the line is limited, partition names my be truncated to fit.
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FACILITY
/FACILITY="*" (D)
Specifies the facility name for which information should be displayed.
By default, information is displayed for all Facilities.
/FULL
/NOFULL (D)
Gives a detailed listing of server partition information.
The following items are displayed:
• Key segment low and high bounds
• Counts of the active and free servers bound to the partition
• Counts of the active and recovered transactions for the partition
Meaning
Key range is recovering or awaiting journal access
Primary server is ready to accept transactions
Secondary server is catching up with primary
Standby take-over is in progress
Secondary is ready, primary is still recovering
shows from which node recovery information may be
Last Rcvy BE:
Txns Rcvrd: shows the number of transactions actually recovered.
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
SHOW PARTITION
command. If no SET ENVIRONMENT
RTR Command Line Interface 6–153