Show Client - Compaq AA-Q88CE-TE System Manager's Manual

SHOW CLIENT

Display information about client channels.
Format
SHOW CLIENT
Command Qualifiers
/CLUSTER
/FACILITY
/FULL
/IDENTIFICATION=process-id
/NODE[=node-list]
/OUTPUT[=file-spec]
Description
The
SHOW CLIENT
Information such as PID, key range, state, event mask and event name are
displayed.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/IDENTIFICATION=process-id
/NOIDENTIFICATION (D)
Specifies the PID of the process for which information is displayed. The default
(/NOIDENTIFICATION) displays information for all clients.
/FACILITY
/FACILITY="*" (D)
Specifies the facility name for which information should be displayed.
By default, information is displayed for all Facilities.
/FULL
none (D)
Specifies a detailed listing of client information.
Defaults
/NOCLUSTER
/FACILITY="*"
none
/NOIDENTIFICATION
/NODE=default-node-list
/OUTPUT=stdout
command displays information about client channels.
/NODE nor /CLUSTER is specified then the command is executed on the
SET ENVIRONMENT
SHOW CLIENT
command. If no
SET ENVIRONMENT
RTR Command Line Interface 6–131