Show Facility - Compaq AA-Q88CE-TE System Manager's Manual

SHOW FACILITY

SHOW FACILITY
Show the names, configuration and status of one or more facilities.
Format
SHOW FACILITY [facility-name]
Command Qualifiers
/BALANCE
/CLUSTER
/CONFIGURATION
/COUNTER[=counter-name]
/FULL
/LINKS
/STATE
/OUTPUT[=file-spec]
/NODE[=node-list]
Description
The
SHOW FACILITY
facilities on the node where the command is executed. If no qualifiers are used,
only the facility name or names and the roles in the facility on the node are
displayed.
Parameters
facility-name
Specifies the name of the facility you want to display.
wild cards ("*" and "%"), in which case all matching facilities will be displayed. If
facility-name
Qualifiers
/BALANCE
/NOBALANCE (D)
Specifies that the load-balancing status of the facility is also displayed. See
Section 2.6, Router Load Balancing for details of load-balancing.
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
6–136 RTR Command Line Interface
Defaults
/NOBALANCE
/NOCLUSTER
/NOCONFIGURATION
/NOCOUNTER
/NOFULL
/NOLINKS
/NOSTATE
/OUTPUT=stdout
/NODE=default-node-list
command shows the names, configuration and status of
is omitted all configured facilities are displayed.
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
Facility-name may contain
command. If no SET ENVIRONMENT