SHOW NODE
SHOW NODE
Shows the node network status, the autoisolation state and the node inactivity
timer.
Format
SHOW NODE
Command Qualifiers
/CLUSTER
/NODE[=node-list]
/OUTPUT[=file-spec]
Description
The
SHOW NODE
disabled) and the node inactivity timer.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
/OUTPUT
Related Commands
•
SET NODE/ISOLATE
•
SET LINK
6–150 RTR Command Line Interface
shows the network status, the autoisolation state (enabled or
/NODE
nor
/CLUSTER
is specified then the command is executed on the
SET ENVIRONMENT
is omitted then the command is executed only on the node where the
or
file-spec
is omitted then the standard or default output is used.
Defaults
/NOCLUSTER
/NODE=default-node-list
/OUTPUT=stdout
command. If no
SET ENVIRONMENT
. If
node-list
. If
file-spec