Set Link - Compaq AA-Q88CE-TE System Manager's Manual

SET LINK

SET LINK
Sets various link related options.
Format
SET LINK link-name
Command Qualifiers
/AUTOISOLATE
/ENABLE
/CHECKSUM
/CLUSTER
/INACTIVITY_TIMEOUT[=secs]
/NODE=node-list
/OUTPUT[=file-spec]
/SUSPECT
Description
The
SET LINK
enabled or disabled, link autoisolate, link checksum and link inactivity timeout.
The parameter
honored (or not). Note that disabling the link prevents incoming connections over
an established link. It only takes effect when new connect attempts are made. It
does not effect the ability to connect to a node whose link has been disabled. The
link-name
The current state of the link can be displayed with the
command. When looking at connection problems both ends of the link counters
should be used with the
Qualifiers
/AUTOISOLATE
/NOAUTOISOLATE (D)
Any RTR node may disconnect a remote node if it finds the remote node is
unresponsive or congested. The normal behavior following such action is
automatic network link reconnection and recovery.
Node autoisolation allows a node (the isolator) to disconnect a congested or
unresponsive remote node (the isolatee) in such a way that when the congested
node attempts to reconnect it receives an instruction to close all its network links
and cease connection attempts. A node in this state is termed isolated.
Some applications require that a node which is suspected of causing congestion
(that is, not processing network data sufficiently quickly) is isolated from the
rest of the network, so as to cause minimum disruption. The node autoisolation
feature meets this requirement.
6–112 RTR Command Line Interface
Defaults
/NOAUTOISOLATE
/DISABLE
/NOCHECKSUM
/NOCLUSTER
/INACTIVITY_TIMEOUT=node-default
/NODE=default-node-list
/OUTPUT=stdout
/NOSUSPECT
command sets options for one or more or links. The options are link
is the node from which connect attempts are to be
link-name
can be wildcarded.
SHOW LINK/COUNTER
SHOW LINK/STATUS
command.