Show Process - Compaq AA-Q88CE-TE System Manager's Manual

SHOW PROCESS

SHOW PROCESS
Display information about processes which are using RTR.
Format
SHOW PROCESS
Command Qualifiers
/CLUSTER
/COUNTER[=counter-name]
/FULL
/IDENTIFICATION=process-id
/NODE[=node-list]
/OUTPUT[=file-spec]
Description
The
SHOW PROCESS
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither
nodes specified by the latest
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNTER[=counter-name]
/NOCOUNTER (D)
Specifies that the process counters are also to be displayed.
name of the counter to be displayed. If
will be displayed.
/IDENTIFICATION=process-id
/NOIDENTIFICATION (D)
Specifies the process about which information is required. The default
(/NOIDENTIFICATION) displays all processes using RTR.
/FULL
/NOFULL (D)
Equivalent to specifying
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
command was issued.
6–156 RTR Command Line Interface
Defaults
/NOCLUSTER
/NOCOUNTER
/NOFULL
/NOIDENTIFICATION
/NODE=default-node-list
/OUTPUT=stdout
command displays information about the processes using RTR.
nor is specified then the command is executed on the
/NODE /CLUSTER
SET ENVIRONMENT
may contain wild card characters.
counter-name
/COUNTER
is omitted then the command is executed only on the node where the
command. If no
is omitted then all counters
counter-name
.
SET ENVIRONMENT
counter-name is the
. If
node-list