Appendix B At Dialing Parameter Registers - Nortel Meridian SL-100 Reference Manual

Appendix B
AT dialing parameter registers
The software reset command Z may be used to reset all the registers to their
default values. Table 14-1 describes the Hayes keyboard dialing parameter
registers.
Note 1: All values are in decimal form.
Note 2: The firmware does not perform a range check on the value assigned
to an S register. The range in Table 14-1 only indicates those values that
give the expected results. Any other values may or may not function as
desired and are not flagged as an error when the command is processed.
Valid ASCII codes range from 0 to 127. Values larger than 127 may disable
the function associated with that S register. Values larger than 255 are
accepted without an error, but are stored in module 256.
Table 14-1xxx
Hayes keyboard dialing parameter registers
Register Range
S0 0–255 rings
S1 0–255 rings
S2 Any valid ASCII code
S3 Any valid character used for
carriage
S4 Any valid ASCII code
S5 0–32, 127 ASCII codes
S7
S8 0–255 sec
S10 1–255 x (0.1) sec
Meridian SuperNode MSL-100 Meridian Modular Telephones Reference Manual MSL11
Default Description
0 number of rings before answer
0 counts number of rings
43 escape code character
13 ASCII code return
0 character used for line feed
8 character used for Backspace
wait time for carrier
2 pause time for comma (,) (not
supported)
7 loss of carrier timeout (not used)
—continued—
14-1