Nortel Meridian SL-100 Reference Manual page 54

2-30 Installation procedures
10
11
12
13
14
15
555-4001-114 Standard 10.02 November 1999
If
the telephone is not already
equipped with a display option
you are replacing an existing display
option
Removing the existing display
Remove the two or three screws from the display module. Remove the display
module from the telephone.
If
the telephone is an M2008 or
M2008HF model
the telephone is a model other than
the M2008 or M2008HF
Installing the display option board
Connect the P0738600 cable to the J12 connector of the display board. Place
the board on the mounting post.
Insert the self-tapping Phillips-head screw into the mounting hole (near the top).
Tighten it firmly with a Phillips screwdriver.
Connect the loose end of the P0738600 cable to the J3 pins of the telephone.
Press down until the connector slides onto the J3 pins on the mother board and
is firmly seated. See Figure 2-7.
Do
Step 13
Step 11
Do
Step 13
Step 15