Installing And Replacing The External Alerter - Nortel Meridian SL-100 Reference Manual

2-32 Installation procedures
18
19
20
21
22
23
24

Installing and replacing the external alerter

Procedure 2-10 describes how to install and replace the external alerter in
the Meridian modular telephone sets.
Procedure 2-10
Installing or replacing the external alerter
1
2
3
4
5
6
555-4001-114 Standard 10.02 November 1999
Fold the ribbon cable near the connector and carefully work the ribbon cable
connector onto the P4 pins of the mother board until it is firmly seated. Route
the cable flat beside the power supply board, gathering excess cable under the
display. Be careful not to to press the cable beneath alignment posts or studs
of the base.
Installing the new display module
Position the display module in place. Insert the self-tapping Phillips-head
screws into the mounting holes. Tighten them firmly with a #1 Phillips
screwdriver.
Replace the base. If the telephone is equipped with an MCA, reconnect the
data cable to the appropriate jack.
Replace the footstand. Make sure the stand is firmly seated to the base.
Tighten all screws, reconnect all cords, and place the telephone in the normal
operating position.
For tracking purposes, place the label supplied with the display option on the
bottom cover of the set.
You have successfully completed this procedure.
Remove the handset, place the telephone upside down on top of a level, solid
surface covered with soft material or paper to prevent damage to movable keys
and to the telephone face.
Disconnect all cords from the telephone.
Loosen and remove the two screws from the stand assembly of the telephone.
Unsnap the stand assembly by grasping the plastic extension and pulling it
upward.
Set the plastic extension aside taking care not to misplace the mounting
hardware from the telephone.
If the telephone is equipped with an MCA, unplug the data cable from the
appropriate jack.
Remove the four screws securing the bottom cover of the telephone set to the
top cover.