Data Terminal Installation - Nortel Meridian SL-100 Reference Manual

9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24

Data terminal installation

To connect a data terminal to the Meridian modular telephone, perform the
steps in Procedure 2-2.
Meridian SuperNode MSL-100 Meridian Modular Telephones Reference Manual MSL11
Ensure that this latch-tab is firmly snapped into place.
If you are installing
an older model M2008 with display,
M2616, M2016S, or M2216ACD,
any set with Meridian
Communications Adapter (MCA) or
external power
Connect the 2-conductor line cord to the telephone base.
See Figure 2-1.
Tuck the line cord under the seven restraining tabs.
This allows the telephone to sit level on the desk.
Insert the line cord into connecting block.
The TELADAPT connectors have a latch-tab, which ensures correct alignment
and prevents the cord from being pulled out inadvertently during service.
Ensure that this latch-tab is firmly snapped into place.
If the unit is so equipped, plug an electrical cord into the external power supply.
Turn telephone right side up, and place in the final position.
Print the directory number on designation card.
Remove the number lens by inserting the end of a paper clip into the hole at the
middle of the lens and levering upwards.
Insert designation card.
Snap lens with card back in place.
Designate button labels for key designations.
Fold labels, insert inside plastic button cover, and snap button cover over the
movable key, pressing down on key, as required.
Repeat Steps 21 and 22 for all keys.
You have completed this procedure.
Installation procedures 2-3
Do
Steps 11 through 23