Nortel Meridian SL-100 Reference Manual page 228

9-4 Hayes keyboard dialing
Table
P66 command screens
Initial
screen
Screen 1
Screen 2
Screen 3
Screen 4
The product codes associated with each are 960, 240, and 122, respectively,
and correspond to the values that are assigned to the S52, S53, and S54
registers.
To select the desired emulation, press P66. Scroll through the choices.
When you have found the desired screen, press P. For information on Nortel
KBD and P66 implementation, refer to Chapter 8, "Nortel keyboard
dialing", in the section titled "Implementing the P66 command".
To return to Hayes keyboard dialing, you must either enter the P66
command and reselect one of the Hayes KBD dialing options or enter an AT
command from the Nortel KBD state.
The default screen selection depends upon the KBDTYPE field of the MCA
profile. If the field specifies Hayes, the default is Screen 1. If the field
specifies SYMB, the default is Screen 4.
To see which screen is currently selected, use the P62 command. The fourth
screen of the P62 command previously showed only the SPEED
RESTRICTION state of ON or OFF. The P66 command uses the lower half
of the screen to show the currently selected P66 state. One of the following
screens appear as the fourth screen of P62 where xxx represents ON or OFF:
555-4001-114 Standard 10.02 November 1999
9-1xxx
Emulation selection
Smartmodem 9600
Smartmodem 2400
Smartmodem 1200
Nortel KBD Dialing
SPEED RESTRICTION xxx
SMARTMODEM 9600
SPEED RESTRICTION xxx
SMARTMODEM 2400
SPEED RESTRICTION xxx
SMARTMODEM 1200
Action
(Scroll <<< >>>)
Press P to select emulation and exit.
Press P to select emulation and exit.
Press P to select emulation and exit.
Press P to select emulation and exit.