Nortel Meridian SL-100 Reference Manual page 254

10-16 Testing and maintenance
Neither the ASR Out or the ASR In process is available during an image. If
the user attempts to perform the ASR process, treatment is given.
If a user performs the ASR Out process and afterwards realizes that it was a
mistake, only the user can return the LEN to service. The user must access
table ASRTABLE and delete the entry corresponding to the personal
identification code entered by the user. Next, the user must access the LTP
level of the MAP station and busy the user's line before returning it to
service.
Procedure 10-8
ASR Out process
1
2
3
4
5
6
7
555-4001-114 Standard 10.02 November 1999
Place the set off-hook with the PDN.
Response:
Dial tone occurs.
Dial ASR out code (datafilled in table IBNXLA).
Note: Attempting to dial the ASR Out code on a secondary DN of the set
causes treatment to be given.
Response:
Special dial tone occurs.
Dial the required ASR authorization code.
Response:
Special dial tone is given for successful authorization. Dial tone is given for the
first invalid code. Treatment is given for the second invalid authorization code.
Dial the required personal authorization code.
Response:
Special dial tone is given for successful authorization. Dial tone is given for the
first invalid code. Treatment is given for the second invalid authorization code.
Dial the six-digit ID code.
Note: Remember this number. It is used again in Procedure 10-9.
Response:
Dial tone is given for the duplicate ID code. Confirmation tone is given for
successful authorization and the system disconnects the call. The LEN
associated with the set and LEN of the associated data device are taken out of
service by setting the line states to INB. The set's datafill is moved from the old
LEN to a virtual LEN.
Unplug the telephone set.
Take the set to its new location.