Emulation Selections - Nortel Meridian SL-100 Reference Manual

8-4 Nortel keyboard dialing
Table

Emulation selections

Initial screen
Screen 1
Screen 2
Screen 3
Screen 4
The product codes associated with each are 960, 240, and 122, respectively,
and correspond to the values that are assigned to the S52, S53, and S54
registers. For information on S registers, refer to Chapter 9, "Hayes
keyboard dialing", and Appendix B, "AT dialing parameter registers".
The default screen selection depends upon the Hayes KBDTYPE field of the
MCA profile. If the field specifies HAYES, the default is Screen 1. If the
field specifies SYMB, the default is Screen 4.
The user can see which screen is currently active by entering the P62
command. The P66 command uses the lower half of Screen 4 to show the
P66 current state. One of the following screens appear as the fourth screen
of P62, where xxx represents ON or OFF:
To select a specific emulation, press P66. Scroll through the choices. When
the emulation choice appears on the screen, press P. For information on
Hayes keyboard dialing and P66 implementation, refer to Chapter 9, "Hayes
keyboard dialing".
555-4001-114 Standard 10.02 November 1999
8-2xxx
SPEED RESTRICTION xxx
SMARTMODEM 9600
SPEED RESTRICTION xxx
SMARTMODEM 2400
SPEED RESTRICTION xxx
SMARTMODEM 1200
SPEED RESTRICTION xxx
HAYES COMPATIBLE MODEM
SPEED RESTRICTION xxx
NT KBD DIALING
Emulation selection
Smartmodem 9600
Smartmodem 2400
Smartmodem 1200
Nortel KBD Dialing
Action
(Scroll <<< >>>)
Press P to select
emulation and exit.
Press P to select
emulation and exit.
Press P to select
emulation and exit.
Press P to select
emulation and exit.