Determining Transceiver Support For Acx5400; Cable Specifications For Qsfp+ And Qsfp28 Transceivers - Juniper ACX5448-D Hardware Manual

Determining Transceiver Support for ACX5400

You can find information about the pluggable transceivers and connector types supported on your Juniper
Networks device by using the Hardware Compatibility Tool. The tool also documents the optical and cable
characteristics, where applicable, for each transceiver. You can search for transceivers by product—and
the tool displays all the transceivers supported on that device—or by category, interface speed, or type.
The list of supported transceivers for the ACX5400 is located at
https://apps.juniper.net/hct/product/#prd=ACX5448.
CAUTION:
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
SEE ALSO

Cable Specifications for QSFP+ and QSFP28 Transceivers

Cable Specifications for QSFP+ and QSFP28 Transceivers
The 40-Gigabit Ethernet QSFP+ and 100-Gigabit Ethernet QSFP28 transceivers that are used in ACX
Series routers use 12-ribbon multimode fiber crossover cables with female MPO connectors (SR4 optics
only). The fiber can be either OM3 or OM4. Juniper Networks does not sell these cables.
CAUTION:
cable.
TIP: Ensure that you order cables with the correct polarity. Vendors refer to these crossover
cables as key up to key up, latch up to latch up, Type B, or Method B. If you are using patch panels
between two QSFP+ or QSFP28 transceivers, ensure that the proper polarity is maintained
through the cable plant.
If you face a problem running a Juniper Networks device that uses a
To maintain agency approvals, use only a properly constructed, shielded
74