Lubrication 500 Hours - Kalmar DRF420-60S5 Maintenance Manual

Table of Contents

Grease point wheel hub

Grease points wheel spindle

1. Upper grease point

2. Lower grease point

C Preventive maintenance – Preventive maintenance

Lubrication 500 hours

1 Clean the area around each grease cup before greasing.

2 Grease all points with lubrication grease, see section F Techni-

Wheel hub and wheel spindle

3 Raise the right steering wheel with a jack (40 ton) so that wheel

bearings and wheel spindle are relieved of stress, do not lift to

a height where the wheel hangs freely.

4 Grease the wheel hub until grease comes out at the seal on the

hub's inside.

Lift the seal ring's lip with a small screwdriver to facilitate

pressing out of air. Grease until grease comes out by the seal.

5 Grease the wheel spindle's upper and lower bearings.

6 Lower the wheel.

7 Repeat steps 3 - 7 for the left steering wheel.

Maintenance manual DRF 400–450

https://www.forkliftpdfmanuals.com/

Work carefully so that the seal is not damaged.

It is important that both upper and lower bearings are

greased separately since the grease is not pressed be-

tween the bearings.

Table of Contents