Rims - Kalmar DRF420-60S5 Maintenance Manual

18
page –
page –
A
Max 0,5 mm
UDRF01.04GB
6 Suspension – 6.3.2 Rims
Tyres, changing
Changing tyres is complicated and dangerous work.
FATAL DANGER!
Leave tyre work to authorized personnel/ tyre com-
pany.
6.3.2
Rim, checking
Perform the following checks to minimize risks of
accidents for all rims that can be dismantled.
Always use the correct size of tyre and a design that
is compatible with the type and size of the rim.
Over-dimensioned tyres must not be used.
Replace all damaged, worn or corroded rims or
mounting parts.
1 Dismantle the rim, see Tyres, changing page 18.
2 Carefully clean the outside of the rim edge with a steel brush.
3 Measure wear after the lock ring.
The lock ring's wear on the rim edge often leaves a mark, A in
the figure. The mark shows up between the ends of the lock
ring.
Measure depth of the wear at point A with a steel ruler and
sliding calipers. If wear exceeds 0.5 mm, the rim, lock ring and
the rim bead seat taper must be discarded and replaced with
new parts.
Maintenance manual DRF 400–450
https://www.forkliftpdfmanuals.com/
D AN GE R

Rims

D AN GE R