Controls And Instrumentation; Brake Pedal - Kalmar DRF420-60S5 Maintenance Manual

4
page –
Set screw for adjusting clearance between brake
pedal and brake valve. (Illustration shows loose

brake pedal.)

Lubrication points, brake pedal. (Illustration shows
loose brake pedal.)
UDRF01.04GB
4 Brakes – 4.1 Controls and instrumentation
4.1
4.1.1
Brake pedal, checking and adjusting
1 Clean the floor around the brake pedal and check that nothing
blocks movement of the brake pedal.
2 Check that the brake pedal springs back sufficiently and that
the clearance between brake pedal and brake valve is 1–1.5
mm. If needed, adjust the brake pedal's set screw to obtain the
correct clearance.
3 Check that the pedal's travel is smooth.
4 Grease the pedal hinges with universal grease "EP2".
5 Check that the rubber on the pedal is intact and that the tread
pattern isn't worn out. Change if necessary.
Maintenance manual DRF 400–450
https://www.forkliftpdfmanuals.com/
Controls and
instrumentation
Brake pedal