Lift Boom - Kalmar DRF420-60S5 Maintenance Manual

page –
1. Side-mounted glide plates
2. Lower glide plates
1. Upper glide plates
2. Side-mounted glide plates
3. Lower glide plates
7 Load handling – 7.3.10 Lift boom
7.3.10
Glide plates lift boom, checking
NOTE
When adjusting side-mounted glide plates, it is important to
check the clearance for the whole boom's stroke.
1 Place the boom in the lowest position (fully retracted).
2 Check wear of the side-mounted glide plates at the leading
NOTE
3 Check the clearance between the boom and glide plate, clear-
NOTE
4 Check thickness of the lower glide plates at the leading edge of
5 Check the clearance between the boom and stop at the leading
6 Check wear of the lower and side-mounted glide plates at the
NOTE
7 Check the clearance between the boom and glide plate, clear-
8 Check thickness of the upper glide plates at the trailing edge of
Maintenance manual DRF 400–450
https://www.forkliftpdfmanuals.com/

Lift boom

edge of the lift boom. If needed, remove the glide plate and
measure the thickness.
Thickness should be at least 25 mm.
If the glide plate's thickness is less than 25 mm, the glide
plate may work loose from the bracket, which may result
in boom damage.
ance should be 1 mm, adjust with spacer plates if needed.
The inner boom shall be centred in the outer boom.
the lift boom. If needed, remove the glide plate and measure
the thickness.
Thickness should be at least 15 mm.
edge/top edge of the boom, clearance may be max. 3 mm. Ad-
just the glide plates with spacer plates if needed.
trailing edge of the lift boom. If needed, remove the glide plate
and measure the thickness.
Thickness should be at least 25 mm.
If the glide plate's thickness is less than 25 mm, the glide
plate may work loose from the bracket, which may result
in boom damage.
ance should be 1 mm, adjust with spacer plates if needed.
the lift boom. If needed, remove the glide plate and measure
the thickness.
Thickness should be at least 15 mm.
13
UDRF01.04GB