Connecting And Turning On The Test Set - Agilent Technologies Option H48 Multiport Test Set Z5623A User's And Service Manual

Installation

Connecting and Turning on the Test Set

The test set is shipped from the factory with the GPIB address set to 12.
NOTE
Connecting and Turning on the Test Set
Make the connections shown in
Connection Diagram."
network analyzer to the test set. If you intend to verify the performance
of the test set, use the long RF cables listed in
the short ones.
Table 2-3 RF Cables Connecting Network Analyzer to Test Set
Length
Long
Short
Plug power cords into the test set. Turn both instruments on.
Allow the test set to warm up for at least 2 hours. For the most stable
NOTE
and accurate measurements, leave the test set turned on at all times.
2 -14
Figure 2-9, "Detailed Equipment
The figure shows two RF cables connecting the
Part No. Purpose
8120-4781 Verification of test set performance
8120-4782 Measurement of multiport devices
Agilent Technologies Z5623A Option H48
Table 2-3. Otherwise, use