Saving The Limit Test File; Checking The Limit Test File - Agilent Technologies Option H48 Multiport Test Set Z5623A User's And Service Manual

Performance Verification
Setting Up Limit Testing

Saving the Limit Test File

Step 1. Click File on the menu bar. When the File menu appears, scroll down to
the Save As... button and click it. See
Step 2. When the Save As window comes up as shown in
name that includes the words, "return loss," the words, "port active",
and the date of the calibration listed in
example, if the calibration file is named, "cal_06_17_01", an appropriate
file name for this step would be, "return_loss_port_active_with_
06_17_01_cal". See
in Table 5-3 on page

Checking the Limit Test File

Step 1. Connect an RF cable from Port 1 of the network analyzer to Test Port 1
of the test set. Connect an RF cable from Port 2 of the network analyzer
to the Reflection Port of the test set.
Step 2. If the test set is turned off, turn it on. If the test set is already turned
on, turn it off, then back on again. This causes the test set to execute
the "*rst;" command, which is equivalent to the "refl_01;" command
combined with the "tran_08;" command.
Step 3. Recall the calibration file listed in
"How to Recall a
should look something like
5 -22
Figure 5-16. After entering the file name, record it
5-7. Next, click the Save button.
Table 4-1 on page
Calibration" on page
Figure 5-17.
Agilent Technologies Z5623A Option H48
Figure 5-14.
Figure 5-15, type a file
Table 4-1 on page 4-13. For
4-13. (Consult
4-14.) The resulting display