Checking The Limit Test File - Agilent Technologies Option H48 Multiport Test Set Z5623A User's And Service Manual

Checking the Limit Test File

Step 1. Connect an RF cable from Port 1 of the network analyzer to Test Port 1
of the test set. Connect an RF cable from Port 2 of the network analyzer
to the Reflection Port of the test set.
Step 2. If the test set is turned off, turn it on. If the test set is already turned
on, turn it off, then back on again. This causes the test set to execute
the "*rst;" command, which is equivalent to the "refl_01;" command
combined with the "tran_08;" command.
Step 3. Recall the calibration file listed in
"How to Recall a
should look something like
Figure 5-17 Insertion Loss Test Setup, Cal File Recalled
Agilent Technologies Z5623A Option H48
Table 4-1
Calibration" on page
Figure 5-17.
Performance Verification
Setting Up Limit Testing
on page 4-13. (Consult
4-14.) The resulting display
5 -17