Renaming the Calibration File
In this section you will rename the calibration file to make it easier to
identify and retrieve.
Step 1. Minimize the network analyzer window. (If you are not sure how to do
this, refer to
on page 3-2.)
Step 2. Double-click the "My Computer" icon on the network analyzer display.
This icon can be seen in the upper left-hand corner of Figure 3-8 on
page 3-14.
Step 3. The window shown in
icon in that window.
Figure 4-11
"My Computer" Window
Agilent Technologies Z5623A Option H48
Step 5
of "Preparing the Analyzer to Control the Test Set"
Figure 4-11
Calibrating the Network Analyzer
Renaming the Calibration File
will pop up. Click the Hard Disk (C:)
4-7