Installing The Fork Legs; O Removing The Fork Protector; Main Work; Remove Screws - Husqvarna FC 450 2018 Repair Manual

6.9

Installing the fork legs

6.10

Main work

-
Position the fork legs.
✓ Air bleeder screw
the front.
f)
✓ Valve
Info
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
H01182-10
must be flush with the upper edge of the upper triple
clamp.
The air suspension is located in the left fork leg. The
pressure and rebound damping is located in the right
fork leg.
-
Tighten screws

Guideline

Screw, top triple
clamp
-
Tighten screws@).
Guideline
Screw, bottom triple
clamp
-
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front
brake caliper
-
Position the brake line and the clamp. Mount and tighten
C,.
screws
Finishing work
-
Install the front wheel.
-

Remove screws

-
Remove screws @ and take off the left fork protector.
0
-
Remove screws
S01902-10
FORK, TRIPLE CLAMP 6
O
of the right fork leg is positioned to
of the left fork leg faces the front.
8.
M8 17 Nm (12.5 lbf ft)
M8 12 Nm (8.9 lbf ft)
M8 25 Nm (18.4 lbf ft)
(8 p. 121)
O
and take off the clamp.
(s)
and take off the right fork protector.
C,.
®

Loctite

243
™
...
...
19