Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.8
Installing the fork legs
(All standard EXC/XC-W models)
–
Loosen screws
–
Loosen screws
E00376-10
(All Six Days models)
–
Loosen screws
–
Loosen screws
E00377-10
Main work
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red adjusting screw).
The compression damping is located in left fork leg COM (white adjusting
screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
H01595-10
upper triple clamp.
(All standard EXC/XC-W models)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
V00334-11
(All Six Days models)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
V00355-11
. Take out the left fork leg.
. Take out the right fork leg.
. Take out the left fork leg.
. Take out the right fork leg.
are positioned toward the front.
.
M8
.
M8
.
M8
.
M8
53
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)
17 Nm
(12.5 lbf ft)
15 Nm
(11.1 lbf ft)
Advertisement
Table of Contents
