Husqvarna FC 450 2018 Repair Manual page 158

16 BRAKE SYSTEM
156
8.
-
Mount bleeder cover
I Bleeder cover (00029013006)
-
Connect the bleeding device.
I Bleeding device (00029013100)
8.
-
Open shut-off valve
• Info
I
Follow the instructions in the Owner's Manual of the
bleeding device.
-
Ensure that the filling pressure is set on pressure gauge 6).
Correct the filling pressure on pressure regulator G) if neces­
sary.
Guideline
I Filling pressure
C,
-
Pull off protection cap
bleeder bottle hose.
I Bleeding device (00029013100)
0
-
Open bleeder screw
Info
Drain until fresh brake fluid emerges in the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
8.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerg-
ing.
• Info
I
Overfilling the brake fluid reservoir is prevented.
-
Tighten the bleeder screw. Remove the bleeder bottle hose.
Attach the protection cap.
-
Disconnect the bleeding device. Remove the bleeder cover.
-
Stand the vehicle upright.
-
Correct the brake fluid to marking (D.
I Brake fluid DOT 4 / DOT 5.1
-
Mount and tighten the screw cap with the membrane and 0-
ring.
• Info
I
Clean up overflowed or spilled brake fluid immediately
with water.
(8 p. 306)
(0 p. 306)
I 2 ... 2.5 bar (29 ... 36 psi)
of the bleeder screw. Connect the
(8 p. 306)
by approx. one half turn.
(0 p. 302)