Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.7
Removing the fork legs
11.8
Installing the fork legs
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
Info
Do not pull the hand brake lever when the front wheel is removed.
120315-10
–
Loosen screws
–
Unscrew screws
H00312-10
Main work
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red adjusting
screw). The compression damping is located in left fork leg COMP (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
402556-10
upper triple clamp.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
H00312-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Position the brake line and clamp. Mount and tighten screws
120315-11
Finishing work
–
Install the front wheel.
p. 33)
(
p. 66)
and take off the clamp.
and take off the brake caliper.
. Take out the left fork leg.
. Take out the right fork leg.
are positioned toward the front.
.
M8
.
M8
M8
(
p. 66)
17 Nm (12.5 lbf ft)
12 Nm (8.9 lbf ft)
.
25 Nm
Loctite
®
243™
(18.4 lbf ft)
.
35
Advertisement
Table of Contents
