Oil Pressure Control Valve, Removing - Husqvarna FC 450 2018 Repair Manual

17.4.3

oil pressure control valve, removing

• - e
8 - <:)
<t> "'
0- 8
Info
When pressing in, ensure that the section of the
engine case lies flat in order prevent damage.
Only press the bearings in using the outer bearing
race; otherwise, the bearings will be damaged when
they are pressed in.
After the section of the engine case has cooled, check that
the bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it
is likely that they will rotate in the engine case when
warm. In this case, the engine case must be renewed.
Press in shaft seal ring
C,
ring of the shift shaft with the open side facing inward
until it is flush.
Position the bearing retainers.
Mount and tighten screws
Guideline
Screw, bearing
retainer
Position oil spray tube
Mount and tighten screw
Guideline
Screw, oil spray
tube
Mount the dowels.
Blow compressed air through all oil channels and check that
they are clear.
Remove screw plug
Remove pressure spring
D01669-10
8
of the countershaft and shaft seal
@).
MS
6 Nm (4.4 lbf ft)
Loctite
8.
O.
M4 5 Nm (3. 7 lbf ft)
Loctite
O 8.
with sealing washer
8.
@)
and ball
ENGINE 17
® 243
™
® 243
™
...
191