Husqvarna FC 450 2018 Repair Manual page 278

22 CYLINDER HEAD
276
' --•
•
-=
- -- --- - -1--
(D
Position the rocker arm and mount rocker arm shafts
✓ The rocker arm shaft with lubrication bore
on the intake side.
✓ The cut-outs G) face upward.
Info
Make sure that the tapped hole of the rocker arm shaft
is facing outward.
@)
Align drill holes in the rocker arm shafts with drill
0
holes in the cylinder head,
Remove appropriate screw M6,
8.
Mount and tighten screws
Guideline
Screw, rocker arm M7
bearing
Position camshaft retaining bracket @,
0-
Mount and tighten screws
Guideline
Screw, camshaft M7x1
retaining bracket
0.
6)
is installed
15 Nm (11.1 lbf ft)
15 Nm (11 .1 lbf ft)
...