Installing The Clutch Cover - Husqvarna FC 450 2018 Repair Manual

17 ENGINE
17.5.17
230

Installing the clutch cover

-
Using a straightedge and the special tool, check the spring
washer for distortion.
I Feeler gauge (59029041100)
Spring washer distortion
If the specified value is not reached:
- CD
Remove screws
with marking II.
-
Using a straightedge and the special tool, check the spring
washer for distortion.
I Feeler gauge (59029041100)
Spring washer distortion
If the specified value is not reached:
- CD
Remove screws
with marking Ill.
-
Using a straightedge and the special tool, check the spring
washer for distortion.
I Feeler gauge (59029041100)
Spring washer distortion
If the specified value is not reached:
-
Change the clutch facing discs.
-
Position the balancer shaft with special tool
I Locking screw (78129032000)
G
✓ Marking and the special tool are aligned.
-
Mount dowels f!} and position the clutch cover gasket@).
(0 p. 311)
0 ... 0.10 mm (0 ...
0.0039 in)
and mount the spring retainer
(0 p. 311)
0 ... 0.10 mm (0 ...
0.0039 in)
and mount the spring retainer
(0 p. 311)
0 ... 0.10 mm (0 ...
0.0039 in)
O.
(0 p. 315)
...