Husqvarna FC 450 2018 Repair Manual page 151

-
Open shut-off valve
-4!)
•
I
-
Ensure that the filling pressure is set on pressure gauge f).
Correct the filling pressure on pressure regulator
sary.
I Guideline
Filling pressure
-
Pull off protection cap
bleeder bottle hose.
I
Bleeding device (00029013100)
-
Open bleeder screw
•
I
-
Tighten the bleeder screw.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerg-
ing.
•
I
-
Tighten the bleeder screw. Remove the bleeder bottle hose.
Attach the protection cap.
-
Disconnect the bleeding device. Remove the bleeder cover.
-
Add brake fluid up to level (!).
Guideline
Level (!) (brake fluid level
below reservoir rim)
I
Brake fluid DOT 4 / DOT 5.1
-
Position the cover with the membrane. Mount and tighten the
screws.
309386-10
-
Check the hand brake lever for a firm pressure point.
C,.
Info
Follow the instructions in the Owner's Manual of the
bleeding device.
I
2 ... 2.5 bar (29 ... 36 psi)
0
of the bleeder screw. Connect the
(0
(D
by approx. one half turn.
Info
Drain until fresh brake fluid emerges in the bleeder
bottle hose without bubbles.
C,.
Info
Overfilling the brake fluid reservoir is prevented.
5 mm (0.2 in)
(0 p. 302)
Info
Clean up overflowed or spilled brake fluid immediately
with water.
BRAKE SYSTEM 16
0
if neces­
p. 306)
..
149