Frame-Type; Egress Set - ZyXEL Communications VES-1616F-44 User Manual

• Enable ingress checking on the interface.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# ingress-check

33.10.8 frame-type

Syntax:
frame-type <all|tagged>
where
<all|tagged>
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Enable ingress checking on the ports.
• Enable tagged frame-types on the interface.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# ingress-check
sysname(config-interface)# frame-type tagged

33.10.9 egress set

Syntax:
egress set <port-list>
where
<port-list>
An example is shown next.
• Enable port-based VLAN tagging on the switch.
• Enable ports one, three, four and five for configuration.
• Set the outgoing traffic ports as the CPU (0), seven (7), eight (8) and nine (9).
sysname(config)# vlan-type port-based
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# egress set 0,7-9
Chapter 33 Command Examples
Choose to accept both tagged and untagged incoming frames or just tagged
incoming frames on a port.
Sets the outgoing traffic port list for a port-based VLAN.
VES-1616F/1624F-44 User's Guide
255