Table of Contents
Advertisement
SET-UP CONT'D
3. Adjust the MicroChine Variable Speed Control to the
desired rotational speed. Speeds are available from
2500 to 10,000 R.P.M. On any task, start with a
lower speed and increase it within your control.
4. Select and attach the desired drill, mill or abrasive
tool for the task at hand. Insert a small drill bit into
the access hole in the MicroChine housing and shaft
to lock the shaft in position when removing or
installing a tool.
5. There are two power switching options, the finger
switch on the handpiece, or the foot pedal control.
When use of the foot pedal is desired, the pedal
must be attached to the FOOT PEDAL Receptacle
at the rear panel of the system power source.
90
Figure 113. MC-65 Speed Control
Figure 114. Tool Attachment
Figure 115. Foot Pedal Connection
Advertisement
Table of Contents
