FOOT PEDAL
The foot pedal may be used with the PRC 2000 system in
two different manners as described below.
1. FOOT PEDAL Receptacle - Connection of the foot
pedal to this receptacle will allow the Pulse Heat
(PH), Pulse Plate (PP), MicroChine (MC) and Pik &
Paste (PD) features of the system to be actuated by
the foot pedal. Electrical connection from the foot
pedal to each feature is selected by positioning of
the FOOT PEDAL Selector Switch.
2. THERMAL MANAGEMENT CENTER - The foot pedal
may be connected to any unused Output Receptacle
(CH 1, 2 or 3 or AUX 1, 2 or 3) on the rear panel of
the system. Depressing of the foot pedal when
connected in this manner, will activate the vacuum
pump to create vacuum at the SNAP-VAC Port or air
pressure at the Controllable PRESSURE Port.
78
Figure 97. Foot Pedal Connection
Figure 98. Foot Pedal Selector Switch
Figure 99. Aux. Foot Pedal Connection