Table of Contents
Advertisement
TIP SELECTION
Selection of the proper tip for the application is essential to obtain the optimum deposition rate and
amount. Check the specifications of the material manufacturer for recommended tip sizing. The tip size
and duration of the dispense cycle determine amount of material deposition (dot or bead size). Dispense
several dots (or beads) onto a piece of paper or scrap PC board to check for desired results.
Never install a clogged tip. The tip may be clogged with material used in a
previous application. Install a new tip and discard after the required
dispensing operation is completed.
Listed below are the four tip sizes available from PACE.
ITEM
NO.
DESCRIPTION
1
Dispenser Tip, .023" I.D., Pink (pkg. of 5)
Dispenser Tip, .020" I.D., Purple (pkg. of 5)
2
Dispenser Tip, .016" I.D., Blue (pkg. of 5)
3
Dispenser Tip, .013" I.D., Orange (pkg. of 5)
4
Table 4. Available Dispenser Tips
NOTE
PART
NUMBER
1121-0409
1121-0410
1121-0411
1121-0412
83
Advertisement
Table of Contents
