Table of Contents
Advertisement
3. Place POWER Switch in the On ("1") position. All of
the system LEDS will light. The Digital Readout will
read "888" and change to read "1-0". This number may
be different on your unit.
4. Release the TIP SET and Scroll Down Keys. The
Digital Readout will now display "CAL" and only the
three Channel LEDs will remain lit signifying that the
system is now in Calibration (CAL) Mode. NOTE: If a
password has been installed, "P - -" will appear on the
Digital Readout. Enter the password key sequence to
display "CAL".
Figure 78. Digital Readout "888"
Figure 79. Digital Readout "CAL"
63
Advertisement
Table of Contents
