Pace PRC 2000 Operation & Maintenance Manual page 70

Hide thumbs Also See for PRC 2000:
Table of Contents

Advertisement

Listed below are 4 different ways to exit Temperature Setback
Mode.
1. For any individual channel, perform the following
operation.
a) Press and release the CH SELECT Key until the
Setback Channel becomes the Current Channel
shown on the Digital Readout.
b) Press and release the Scroll Up Key.
c) The system will now restore the previous Set Tip
Temperature of the Current Channel.
d) Observe the Digital Readout as the Operating Tip
Temperature increases to the Set Tip Temperature
(if above 180°C (350°F)). For optimum
performance, DO NOT attempt to use the attached
handpiece until Set Temperature is achieved.
2. For any individual channel, the attached handpiece
may be disconnected and reconnected. The
previously stored Set Tip Temperature will be restored
as in method #1 but the Tip Temperature Offset value
70
Figure 93. Changing Channel
Figure 94. Restore Previous Tip Temp.

Advertisement

Table of Contents
loading

Table of Contents