Table of Contents
Advertisement
PIK AND PASTE
Located in the middle of the front panel of the system power source, this portion of the PRC 2000 provides
both a vacuum pick/placement capability (PIK) and a dispensing capability (PASTE) for use with a variety
of solder cremes, high viscosity fluxes and adhesives. Refer to the "Capabilities" portion of this manual for
a complete description of this feature. Following are the Set-Up and Operation instructions for each
feature.
PASTE DISPENSER
SET-UP
1. Install the Dispenser Cubby (PACE P/N 6019-0038)
provided with the system and install onto the left side
of the system power source chassis. Assembly
instructions are enclosed with the cubby.
2. Locate the Paste Dispenser Kit (PACE P/N 6993-
0152) provided with the system.
3. Attach the ridged end of the male quick connect
hose mount Fitting to the Air Hose.
4. Insert the male quick connect hose mount Fitting
(attached to Air Hose) into the female PASTE DISP
Port.
Figure 100. Dispenser Cubby Mounting
Fitting
Air Hose
Figure 101. Air Hose Connection
Figure 102. Paste Dispense Connection
79
Advertisement
Table of Contents
