Pace PRC 2000 Operation & Maintenance Manual page 60

Hide thumbs Also See for PRC 2000:
Table of Contents

Advertisement

CHANGING THE PASSWORD CONT'D
11. Press any key as the second key of the new
Password.
12. Press any key as the third (and last) key of the new
Password.
13. The Calibration Mode has been automatically
entered and the Digital Readout will now display
"CAL". If no calibration parameters need to be
changed, exit Calibration Mode and go to
Temperature Display Mode (normal operation) by
pressing the TIP OFFSET Key. Otherwise, perform
calibration now (refer to the CALIBRATION/SYSTEM
SETUP section). When finished with calibration,
press the TIP OFFSET Key.
The Password is not permanently replaced until
the Calibration Mode is exited normally by press-
ing the TIP OFFSET Key. If AC POWER is
turned off while still in the Calibration Mode, the
new Password will not be saved.
CLEARING A LOST PASSWORD
1. Place the POWER Switch in the OFF ("0") position
and disconnect the AC power cord fom the system.
60
NOTE
Figure 71. Digital Readout "CAL"
Figure 72. Power Off

Advertisement

Table of Contents
loading

Table of Contents