Table of Contents
Advertisement
PANEL CONTROLS CONT'D
13. Press the TIP SET Key once. This is TIP SET
Mode. The TIP SET LED will flash and the Digital
Readout will display the stored Set Tip Temperature
for the Current Channel. As received from the
factory, the Digital Readout will display "OFF". Also,
if no other operation occurs within 6 seconds, the
LED will turn off and the Digital Readout will revert to
the Temperature Display Mode. Pressing the TIP
SET Key a second time will immediately place the
system in the Temperature Display Mode (normal
operation).
14. Plug an auxiliary accessory (if purchased) into
any of the three Aux Power Receptacles (AUX 1,
2 or 3). Repeat step #8.
Notice that each subsequent pressing of the CH
SELECT Key will illuminate the AUX LED and the
Channel LED corresponding to the auxiliary
channel to which the auxiliary accessory is
connected. The sequence in this case would be
CH 1 to CH 2 to CH 3 to CH 1 (plus the Auxiliary
LED) to indicate the active Auxiliary Channel
(AUX 1) and then back to CH 1.
42
Figure 34. Display Stored Tip Temp.
Figure 35. Aux. Accessory Connection
Figure 36. Changing Current Channel
Advertisement
Table of Contents
