Table of Contents
Advertisement
SYSTEM CONT'D
9. Connect handpiece connector plug(s) to THERMAL
MANAGEMENT CENTER (TMC) Power
Receptacle(s) CH 1, CH 2 and/or CH 3 as follows.
a) With the Connector Key end facing the power
source, turn the Locking Ring fully
counterclockwise.
b) Align Connector Key with Receptacle Keyway of
Power Receptacle.
c) Insert connector into Power Receptacle.
d) Turn Locking Ring fully clockwise to lock in
place.
10. To avoid confusion among handpieces, PACE
recommends the use of colored markers (P/N 6993-
0136 Cable Marker Kit) to identify the particular
handpiece power cord and/or air hose. Attach any
two like colored markers, one to each end of the
handpiece power cord or air hose. Select and use a
different colored marker for each handpiece. Labels
are also provided to mark Tip & Tool Stands and Hot
Cubbies with the name of the associated handpiece.
Receptacle on rear panel of power source to enable
foot pedal operation of MICROCHINE (MC), PIK
AND PASTE (PD), PULSE HEAT (PH) and PULSE
PLATE (PP) features (as selected by position of
FOOT PEDAL Selector Switch).
12. Install additional handpieces and accessories as
necessary using the "Set-Up" instructions and the
manual supplied with each handpiece.
13. Plug the prong end of the power cord into a
convenient three wire grounded AC power outlet.
The system is now ready for operation.
14. Read the "OPERATION" section of this manual
32
thoroughly before operating the system.
Figure 17. TMC Handpiece Connection
Figure 18. Foot Pedal Connection
Advertisement
Table of Contents
