OPERATION CONT'D
4. Place the Vacuum Cup and/or the Metal Vacuum Tip gently onto the top surface of the
Component body. Exercise caution to avoid bending of leads on fine pitch devices.
5. Place one finger over the Vacuum Control Port. Vacuum is now being applied to the
Component body.
6. Gently lift the Component off the PC Assembly (removal operation) or out of the component
holder (placement operation).
7. Lower the Component gently into position onto the PC Assembly (placement operation) or
component holder (removal operation).
8. Lift finger or gently slide finger back from the Vacuum Control Port to release the Component.
9. Place the PIK-VAC Power Switch in the "OFF" (0) position when all Component handling
operations are completed.
Figure 111. Pik-Vac Operation
88
Vacuum
PC Assembly
Control
Port
Vacuum Cup
Pik-Vac Handpiece
Component