Table of Contents
Advertisement
The ResisTweez resistance soldering handpiece by its very nature may have
a potential leakage voltage above 2mV. Its use should be restricted to
soldering and auxiliary heating applications in which there is no risk of
electrical over stress (EOS) discharge damage to sensitive components.
PACE ThermoBand tips, which fit the ResisTweez, are specially insulated
to keep leakage below 2mV.
The control knob located above the AC terminals (PULSE HEAT Output Control) controls the amount of
energy delivered to the handpieces. The Green LED will light to indicate that current is flowing to the
handpiece when the foot pedal has been depressed.
PULSE PLATE
The PULSE PLATE section located just to the right of the
PULSE HEAT section allows the operator to safely replate
damaged, worn or repaired connectors, circuit contacts and
edge connectors using simple plating solutions. The swab
plating probe and ground clip connect to the terminals labeled
"DC" while the control knob can be adjusted to regulate the
amount of voltage applied to the area being plated. The
Green LED will light to indicate that voltage is being applied
when the foot pedal is depressed. The LED will shift from
Green to Red if an overcurrent condition is reached. Contact
your local PACE representative for information regarding the
optional PE-210 SwaPlating accessory (P/N 7003-0002) to
the PRC 2000 system.
NOTE
Figure 3. Pulse Plate Section
13
Advertisement
Table of Contents
