Point Table Mode - Mitsubishi Electric MELSERVO-J3 Series Manual

8. PARAMETER UNIT (MR-PRU03)

8.5.6 Point table mode

The flowchart below shows the procedure for setting point table data.
DATA
SHIFT
PARAM
e.g. To set point
table No."255"
press:
2 5
Select a point table No.
Note. This applies to all types of data.
Table read screen
5
Point table data is
displayed.
POS : Point data
SPD : Servo motor
speed
ACC : Acceleration
time constant
DEC : Deceleration
time constant
DWELL : Dwell
: Auxiliary
AUX
function
Select an item with
" "
the keys
or numeric keys.
Position data display
Servo motor speed display
Acceleration time
constant display
Deceleration time
constant display
Dwell display
Auxiliary function display
Press the "Fn" key
to display the range.
8 - 14
e.g. To set setting
value "4567.89",
press:
4 5 6 7
1STEP 8 9
Enter
(Note)
e.g. To set setting
value "0", press:
0
Enter