Operation At Error Occurrence; Cc-Link Communication Error - Mitsubishi Electric MELSERVO-J3 Series Manual

Hide thumbs Also See for MELSERVO-J3 Series:
Table of Contents

Advertisement

11. TROUBLESHOOTING

11.2 Operation at error occurrence

An error occurring during operation will result in any of the statuses indicated in the following table.
Error location
Servo side alarm
occurrence
Option unit
communication error
CC-Link
communication error
Programmable
controller error/STOP
Servo side warning
occurrence

11.3 CC-Link communication error

This section gives the definitions of the indications given in the communication alarm display section.
The servo amplifier has four LED indications.
L.RUN : Lit at normal receive of refresh data. Extinguished when data is not received for a given period of
time.
SD
: Lit when send data is "0".
RD
: Lit when the carrier of receive data is detected.
L.ERR : Lit when the data addressed to the host is in CRC or abort error.
(Note) Communication alarm display LED
L.RUN
SD
RD
Note.
: Lit
: Extinguished
Description
Servo operation
CC-Link data communication
Servo operation
CC-Link data communication
Servo operation
CC-Link data communication
Servo operation
CC-Link data communication
Servo operation
CC-Link data communication
L.ERR
Normal communication is made, but a CRC error sometimes occurs due to noise.
Normal communication
Hardware fault
Hardware fault
Receive data results in CRC error, disabling a response.
Data does not reach the host.
Hardware fault
Hardware fault
Polling response is made, but refresh receive is in CRC error.
Hardware fault
Hardware fault
Hardware fault
Data addressed to the host resulted in CRC error.
Data does not reach the host, or the data addressed to the host cannot be received due to
noise.
Hardware fault
Baud rate setting illegal
Station number setting illegal
Baud rate or station number setting changed midway (ERROR flickers for about 4s)
Data cannot be received due to power-off, power supply failure, open cable, etc.
WDT error occurrence (hardware fault)
: Flicker
Operation
11 - 2
Operation mode
Test operation
CC-Link operation
Stop
Stop
Continued
Continued
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Continued
Stop
Stop
Stop
Stop
Continued
Continued
Continued

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents